4Strokes.com
KTM Home Four Strokes Articles Classifieds Free Ads 4stroke Forums motorbike Games cycle Images quads Videos dirt bike Ride Info 4wheelers Sponsors rider Technical freebies Contests site Search dirt cycle Contact off road
Four-Stroke KTM Dirt Bike, Dual Sport & ATV Tech Info on 4Strokes.com
4Strokes.com Technical: Non-Model Specific | Honda | Kawasaki | | Suzuki | Yamaha | All Other Models
Clutch Bleeding Procedure Clutch Filling & Bleeding Procedure - Learn how to fill and bleed your Maura hydraulic clutch system. Use mineral oil in the system NOT brake fluid.

Crockett's BK ModCrockett's BK Carb Mod - This modification is intended to limit the fuel squirt from the carburetor accelerator pump into the engine for an increase in performance and fuel efficiency. By Rob Crockett

Exhaust Noise Test DataAdobe PDF file Exhaust Noise Test Data (65KB PDF file) - Exhaust noise level (dB) ratings for different model KTM dirt bikes with various aftermarket exhaust systems. Go to CA State Parks Off-Highway Motor Vehicle Recreation Division Website for the latest edition. Submitted by John Franger

How to set KTM fork oil levelHow to set the fork oil level in your KTM - Front suspension performance relies greatly on fork oil quality, viscosity and the amount of oil in each fork leg. By Mike Rosso
KTM Racing Four-Stroke Chain AdjustmentKTM RFS Chain Adjustment - If you are used to adjusting your chain by sight or feel and have not done this procedure yet, you are in for a surprise. By Jon Delameter

KTM Racing Four-Stroke Jetting ModsKTM Racing Four-Stroke Jetting Mods - First and foremost, order a Keihin FCR OCEMN needle. This can be ordered through carburetor supply house. By Jon Delameter

KTM RFS Setup Tricks - This doesn't really take that long to do once you've committed to tearing your bike apart. I sure found a few eyebrow-raisers too, like motor- mount bolts that were finger- tight and near-dry steering head bearings. By Jon Delameter

KTM Racing Four-Stroke Jetting ModsKTM RFS Valve Adjustment - As a general rule of thumb valves get tighter as they pound into the seats over and over again. By Jon Delameter
KTM VIN Number IdentificationAdobe PDF file KTM VIN Identification - How to read the VIN number on your two- or four-stroke KTM motorcycle. Covers most models from 1975 to 2000. By KTM Sport motorcycle

KTM RFS Fork: Rebuild, Oil, Seals and ValvingKTM RFS Fork Rebuild & Valving - Lots of KTM owners seem to have experienced problematic fork seals. By Jon Delameter

Measurement of Exhaust Sound Levels of MotorcyclesAdobe PDF file Measurement of Exhaust Sound Levels of Motorcycles (40KB PDF file) - This SAE Standard establishes the test procedure, environment, and instrumentation for determining the sound levels of motorcycles under stationary conditions. By SAE Motorcycle Committee

KTM Four-Stroke Technical Tips

Triple Clamp Offset - Most of the 2000-2002 KTM Racing Four-Strokes have a triple clamp with an offset of 14mm. This offset makes the bike turn "slow" and would greatly benefit from an offset more like 18-22mm. By 4Strokes.com Your KTM related Tip here

Links to KTM Four-Stroke Technical Information on the Internet

  1. Confused about triple-clamp offset? by Gary Emig
  2. Back-Bleeding Hydraulics Brakes by Kurt Mirtsching
  3. Alert: Brake Failure Recall - 08-09 450XC, 525XC; 09 450SX, 505SX ATVs by CPSC
  4. KTM PDS Shock System by Race Tech
  5. KTM Tips & Tricks (On The Cheap) by John Stichnoth
Got Tech Info? Send us your KTM 4-stroke related tech articles, tips and links, and we'll publish them to 4Strokes.com!
Copyright © 2013 4Strokes.com | All Rights Reserved | Terms of Use | Sitemap | Link to 4Strokes.com | Facebook | Share This Page